Before installing the side dumping mine car, first check the installation position of the mine car, check the track laying, and adjust whether the parallelism and flatness of the two tracks meet the requirements.
The top of the straight track should be at the same level, and the allowable error in the length direction should not exceed 1mm per meter and 3mm per 10m. The allowable error at the corresponding measuring point in the left and right directions shall not exceed 2mm.
After carefully checking that there are no problems, ensure that the center line of the wheel set of the side dumping mine car coincides with the center line of the track according to the installation requirements.
During the test run, observe whether the wheel pair of the side dumping mine car rubs against the track, and promptly handle it if found to prevent damage to the tramcar.
During test run, observe whether the car body inclines, goes out of the track, or overturns after sliding along a slope curve and colliding with another car.
During the test run, observe whether the side dumping mine car is colliding with each other, interfering with each other, and gnawing the rails as it passes through the rails with a small radius of curvature.
The above are some installation methods for side dumping mine car that I have introduced to you. When installing side dumping mine car in the future, you must pay attention to these issues. You can also find a professional installation technician to install them for you when purchasing!
