The existence of mine car is a relatively common production equipment in our daily life and production. It is a mechanical equipment provided by our company for market production throughout the year. Regarding the basic safety test operation skills of coal mining car, I hope you have a brief understanding of the following knowledge.
For many years, mining cart have provided support and help to improve mining production efficiency. As a mine cart manufacturer, the company has a deep understanding of mining cart. Our company has mastered the basic inspection skills of mine carts. The following is the mine cart connection Equipment inspection system, I hope customers and friends can understand.
1. The mine car must clearly check the use of the connection device. If it is found that the connection device has a safety hazard such as the limit of wear or serious deformation, it must be replaced immediately. The replaced connection device must be properly stored and not lost.
2. The long ring, woolen, tank ring, and tank ring used at various locations in the mine are handed over every shift and shall not be lost. If any loss is analyzed, the responsible person will be fined 50-100 yuan.
3. Before using the connecting device, the body must be inspected for cracks, deformation and other defects, otherwise it must not be put into use. The electric locomotive driver is responsible for confirming the connection device of the mine car transported in the flat road.
4. Before the inclined mine car goes uphill, the hooker must replace the connecting device with an anti-jumping shackle. Special measures are required for special materials.
5. The replaced old connection device shall be identified, and the connection device that exceeds the regulations shall be scrapped. The repaired connecting device shall be subjected to a tensile test in accordance with the regulations, and it can be used again after being qualified.
6. The wire rope connecting device used for transportation in inclined shafts must be tested with a tensile force twice its maximum static load each time the wire rope is changed.
7. The connecting device of the narrow gauge mine car must be subjected to a tensile test not less than twice the maximum dead load once a year.
The above seven points of the inspection system for the connection device of the narrow gauge mine car are hoped that customers and friends can understand and master it, and provide support and help for the smoother selection and use of the mine car, and fundamentally improve the production efficiency. The company will continue to innovate and develop the production technology to provide the performance of the mine car.
